This includes the Victron Smart BMS CL 100A  Alternator Charging
Not the unit shown in the Prado 150 image which has additional Mega Fuse for Inverter. For Alternator Charging, the units are the same.

Bluetooth Connected Smart Device

This Victron Smart BMS protects the alternator (and wiring) and the lithium batteries.

Can be used as a system on/off switch.

It is Bluetooth programmed, Bluetooth monitored showing % Maximum Charging, Alterntor Voltage and Lithium Battery Voltage.

 

Battery Protection

This function is similar to a Smart Battery Isolator.

  • Current can flow to the Lithium battery only if the input voltage (= voltage on the starter battery) exceeds 13V.
  • Protect the Lithium battery against excessive charge current which is important when the Lithium battery is at a low state of charge.

 

Alternator Protection

  • Unless a maximum charge current is set, most 12V alternators will overheat and fail if running at maximum output at idle for more than 5-10 minutes.
  • The input current limit is set using Bluetooth and then placing the matching fuse recommended from the Bluetooth app.
  • The maximum charge rate is 100A.

 

Connecting to Fridge and other 12V Devices

  • Connect the appropriate fusing to the 12V post and wire to the Smart Battery Protect. This may be in engine bay but preferably after the fusing close to the 12V devices to be powered up. 
  • The port is short-circuit protected with a peak discharge current of 400A.
  • The Smart BMS will enable charging through this port using a 240V AC Charger. The charger must have Lithium charging profile.

 

Remote System on/off

  • This can be done using a switch OR
  • Using Bluetooth App

 

Safiery Engine Bay Controller

  • Controlls the Smart BMS for Safiery Lithium Batteries
  • Controlls the Smart BMS for Alternator Only Connection with Lithium Start Battery
  • This System WILL NOT WORK without this proprietary module

(LIB135X212V751)

SKU LIB135X212V751