Wiring Harness Includes:
Exact Preformed Cables:
- Alternator to Battery Positive.
- Additional Cable Battery Negative to Chassis
- Fused Cable from Battery Positive (after adding additional Alternator to Battery Positive) to Inverter.
- Inverter to each 48V battery (3 x Power leads 25mm2 Positive and negative to each)
- Smart Shunt with 12V and 48V Positive Battery sense wires.
- Master battery On/Off with Mega Fuse Cable to Inverter Posts.
- 2 x ANS Fuse holders one with 60A ANS fuse, one with 125A ANS fuse for 12V power out to canopy and compressor.
- (12V power cable to tray/canopy not included as some people wont need)
Fused Wiring loom to Cerbo for power
Solar Panels Incoming On/Off and Megafuse
2 x RCBO 16A out with wiring.
2 x Double GPO (one each either side of seat) 15A with wiring loom.
Victron Data cables
CANbus Cables (plug n play)
All numbered to match wiring Diagram (better than our first IKEA Desk assembly)
All cables Lugged and with heat Shrink
If you are a 6/10 on the Ikea self assembly profeciency you can put this kit togther.
You will need a licenced electrician to check 240V wiring but note RCBO will have been tested and is pre-wired by us.
More From This Category